Guide troughs for long travels

For particularly robust plant construction
Material used on the side parts: Galvanised steel / stainless steel upon request

Speciality: Steel guide troughs - very strong and robust for heavy-duty plant construction

• Very strong and robust steel guide trough
• Simple installation with installation sets for butt joint and fastening to the substrate
• Simple attachment directly to the base of the C-profile
• Large selection, 2-piece design, adjustable to chain width
• Available in galvanised steel and stainless steel (materials: AISI 304, 14404, 14571)
• Glide bars are made of high-molecular PE
• Side parts are fitted with appropriate spacing and fastened to the base
• The fixed end module enables quick and easy fastening without drilling
• Conductivity in accordance with DIN EN 61537: Standard

Lets light and dirt through
The igus tubular trough is an easy-to-install, cost-effective trough system for applications with low mechanical stress, speeds of up to 2m/s and travels of up to 50 metres.

• For applications where dirt, swarf and abrasion occur - waste products simply fall through the gaps
• No need to set the correct width as suitable spacers are supplied

Very simple and inexpensive variant
The igus snap-in trough is an easy-to-install, space-saving, low-cost trough system for applications up to 50 metres in length.

• Significantly narrower than conventional troughs
• Quick and easy installation
• Fixed inner width thanks to spacer plates
• No need for time-consuming adjustment of the lateral clearance
• No sharp metallic edges on the inside, as they are covered by connectors
• Narrow trough parts made of galvanised steel (stainless steel upon request)